1

Door Light Curtain Safety Protection

An infrared light beam is set at the entrance and exit. Once an obstacle blocks it, the elevator door will reopen.

2

Collective - Selective Control

The elevator accepts up - and - down signals at intermediate floors.

3

Lock - out Service

By operating the "Run/Stop" key switch installed on the designated floor, the elevator can be started or stopped.

4

Safe Stopping

When the elevator breaks down outside the door area, the controller conducts safety monitoring, and the elevator stops at the nearest floor and opens the door.

5

Arbitrary Service Floor Setting

The elevator can be set to stop at any desired floor.

6

Full - Load Direct Operation

When fully loaded, the elevator will not respond to calls from intermediate floors.

7

Overload Alarm

When overloaded, the elevator keeps the door open and the in - car buzzer rings.

8

Car Emergency Lighting

When the normal lighting power supply in the car is cut off, emergency lighting is immediately provided.

9

Five - Party Intercom Device

People in the car or on the car top can communicate with those in the machine room or monitoring room through this device.

10

Wrong Command Cancellation

If a wrong in - car command button is pressed, pressing the button twice in succession can cancel the command.

11

Dedicated Operation

Dedicated for VIP service. At this time, the elevator no longer accepts hall calls, only in - car commands.

12

Maintenance Operation

A maintenance operation mode for maintenance personnel.

13

Attendant Operation

The elevator can be operated by a dedicated person inside the car.

14

Fire - fighting Control

In case of a fire, when the fire - fighting switch is activated, the elevator will return to the preset floor, open the door, and stop operating.

15

Repeated Door Opening

If the elevator continues to close the door for 15 seconds without locking the door, it will switch to the door - open state.

16

Fault History Record

It can record the 20 most recent faults, including the occurrence time, floor, and fault code.

17

Automatic Return to Base Station

When there is no command or call, the elevator will automatically return to the base station after a certain time (the time can be set through parameters).

18

Automatic Control of Door - opening Time

When there is no attendant, the elevator door - opening time is adjustable.

19

Light - Load Anti - Disorder Function

When the load is small and passengers maliciously press most of the down - direction buttons, the computer will automatically cancel these signals to prevent ineffective operation.

20

Car Arrival Bell

During the elevator's deceleration process, the arrival bells installed on the car top and car bottom will ring to remind passengers in the car and those waiting in the hall that the elevator is arriving at the floor.

21

Automatic Power - off of Car Lighting and Fan during Idle Time

If the elevator has no commands and the idle time exceeds 5 minutes, the car lighting and fan will automatically power off. But when a command or call signal is received, they will automatically power on again.

Optional Function

Front and Rear Door Independent Operation

Independent control of front and rear door opening and closing can be achieved.